FarmTrak™ boots are made for heavy-duty, everyday use, and are tested to the highest standards to ensure top-level performance.
FarmTrak™ boots are CE Mark certifed products, made in an accredited facility with every stage of the design and manufacturing process inspected and tested.
Synthetic Upper: Polyurethane (PU)
Dual Density Outsole: Polyurethane (PU) and Thermoplastic Polyurethane (TPU)
The all-in-one injection-moulded construction process provides a strong bond between the polyurethane upper and outsole. This ensures a water-tight seal and reduces the possibility of separation under stress.
Users should choose the correct size to suit their feet. This will provide maximum comfort and reduce the risk of boot deformation. Ill fitting boots can contribute to trips and falls.
All boots are supplied with an original insole. All testing has been conducted with this device in place. Performance of the footwear will be altered without the presence of this device, or with an alternative insole.
FarmTrak F-Tread safety and non-safety boots are manufactured and tested to comply with the latest EN ISO quality standards. These latest quality standard versions, include all of the parameters of the previous iterations of the standards, with additional stricter requirements to improve performance and protect the user.
Basic requirements - Occupational footwear is not required to have a protective toecap.
Applies to:-
| Property | Description |
|---|---|
| P | Penetration resistance |
| C | Conductive |
| A | Antistatic protection |
| I | Electrically insulating |
| HI | Insulation against heat |
| CI | Insulation against cold: tested for 30 minutes at 1 -20°C |
| E | Energy absorbing in heel seat region |
| WRU | Uppers resistant to water penetration / absorption |
| HRO | Heat resistant outsole: To resist 300°C for 60 seconds |
The non-slip outsole of our F-Tread boots has been tested for slip resistance and has been approved with a rating of SRC (highest).
Applies to:-
The codes indicate that the footwear has met the specified requirements when tested as follows:
| Category | Description |
|---|---|
| SRA | Tested on ceramic tile wetted with dilute soap solution |
| SRB | Tested on smooth steel wetted with glycerol |
| SRC | Tested under both the above conditions (SRA + SRB) |
Basic requirements - Safety footwear must have a 200J toecap.
Applies to:-
| Property | Description |
|---|---|
| P | Penetration resistance |
| C | Conductive |
| A | Antistatic protection |
| I | Electrically insulating |
| HI | Insulation against heat |
| CI | Insulation against cold: tested for 30 minutes at 1 -20°C |
| EN | Energy absorbing heel seat region |
| WR | Whole footwear resistant to water penetration / absorption |
| M | Metatarsal protection |
| AN | Ankle protection |
| WRU | Water resistant upper only |
| CR | Cut resistant upper |
| HRO | Heat resistant outsole: To resist 300°C for 60 seconds |
| FO | Fuel oil resistant sole |
F-Tread SB1 performs up to the highest level of S5.
This rating also includes the lower levels SB, S1 and S4.
| Category | Description |
|---|---|
| SB | Basic requirements - For safety footwear with a toe cap resistant to an impact of 200 Joules |
| S1 | Basic requirements + Closed heel area, Energy absorption at seat area, Antistatic properties, Resistance to fuel oil |
| S4 | S1 + Entirely moulded polymer / rubber upper (e.g Wellington Boots) making them waterproof and leak proof |
| S5 | S4 + Midsole penetration resistance. |